Skip to product information
1 of 1
BRAND | DAVIES CRAIG

Digital Thermatic Fan Switch with 1/4" NPT TempSensor

Digital Thermatic Fan Switch with 1/4" NPT TempSensor

SKU: DC0445 | Cooling
Regular price $127.40 NZD
Regular price Sale price $127.40 NZD
Sale Sold out

This kit comes with two sensors offering a host of different installation optionsfor coolant temperature sensing.

Sensor 1: Temperature Probe (Air or Coolant Fitment)
It senses air temperature as it passes through the radiator with the sensor placed in the radiator fin section or the sensor can also be placed directly into the coolant system in combination with a Temperature Sensor Adaptor Kit(Part 0409) which is availablefrom our store.

Sensor 2: 1/4 NPT Thermal Sensor Kit (Coolant Fitment Only)
The Thermal Sensor can be placed into the thermostat housing, engine block, or directly into the radiator. Ifyou would like to install thissensor in the top radiator hose, It can also be used withTemperature Sensor Adaptor Kit(Part 0409) which is availablefrom our store.

The switch can run 1 or 2 fans andbe used for 12 or 24 volt applications. It has an adjustable temperature range of 40°C to 110°C (104°F to 230°F) whichcan show Centigrade or Fahrenheit.

  • Fan #1 will start once the temperature reaches the set temperature.
  • Fan #2 (if applicable)will start operation 10 seconds after fan #1 starts.
The fan/s will operate until the temperature falls by 5°C below the set temperature.

Sensor Wire length:
  • 142cm in total (Wire from switch 112cm plus sensor connector 30cm)
  • Post 15-Dec-2021= 320cm total (Wire from switch 290cm plus sensor connector 30cm)
* Thesensor wire has been increasedto 320cm from the 15-Dec-2021,batch date 2021

IP66 Rated:
  • Protected from totaldust ingress
  • Protectedfrom high pressure water jets from any direction, limited ingress protection
  • Notwaterproof

* Notes: Kit sold in 12 volt configuration, for 24 volt application you will need to change the two relays with 2 x24 volt relays which are not supplied in the kit. We have 24 Volt relays listed on our store, part #0534.

If using this switch for use withand Electric Water Pump (EWP),it will not vary the speed of the pump in response to enginetemperature but rather turn the pump on and off at your set temperature. For EWP control, we recommend the Digital Controller (Part 8002)which can manage both the EWP and your Thermatic Fans.

Convenient push-button settings allow youto quickly set the temperatureyou wish the Thermatic Fans tobe activated.

  • The Digital Thermatic Fan Switch is supplied with connectors and everything you need for a convenient and simple install.
  • Automaticallyactivates the Thermatic Fans at the set/targeted temperature when extra engine cooling is required
  • Can also be installed to activate an Electric Water Pump and Electric Booster Pump

The Digital Thermatic Twin Fan Switch should be mounted in the engine bay close to the radiator.

View full details